Portable Diamond Glass Art Grinding Tool Machine 220V Stained Glass Grinder

  
Voltage: 220 V, 0.1 A. Rotation speed: 4200r / min. Working table size: 165x165 mm.

Suitable for grinding glass, ceramics and other hard and brittle materials. Two models of grinding wheel for this machine are mcbl1, mcbl58, we send a free MCBL58Grinding Wheel. Inside the rotating shaft (the fine shaft of the grinding head) diameter: 0.7 cm, grinding wheel inner diameter: 0.79 cm.

Mini size and easy to carry. Automatic water available for some sizes (5/8 "1"). New design switch avoid electronic wire. Glass, ceramics, like grinding hard brittle materials. Grinding a variety of geometric shapes: plane, curve, rounded corners, slope, etc.

Before installing the grinding wheel filled with lubricant, the motor shaft grinding wheels must apply a layer of lubricant. The grinding wheel is mounted on the motor shaft, the fixed screw position is higher than the motor shaft. The position of the grinding wheel on the axis must be at least 1/8 diamond part above the operating table. Fasten the grinding wheel clockwise onto the shaft. Installation: Pay attention to the stability of the grinding wheel installed in the engine shaft of the aircraft.

Make sure the grinding wheel is wet. Do not use too much starch when using the low-thickness grinding wheel.

Strength reduces the grinding machine and the life of the grinding wheel. Clean the water tank after use. Remove the container and clean the rest of the residue.

To extend the life of the grinder, remove all grinding wheels and the fixed screw 25 hours after each use and apply lubricant to the motor shaft. If the grinding wheel is not used for a week or longer, it must be ground on the stage so that the direct axis does not get caught. This will help you check the motor shaft and the wheel will keep its habit. When grinding metal, the grinding wheel is damaged and glass can no longer be ground. 1 x 5/8 diamond grinder (MCBL58Grinding Wheel).